Mounted EBC brakes on mazda MX5 NB FL / MK2.5

Mounted EBC brakes

Mounted the EBC brakes and red stuff pads on my mazda MX5 NB FL / MK2.5

Also made a manual which can be found here

The old:

The new:

related postsCommentsRecent CommentsTop Commenters

Previous Pause Next

Next Problem

May

This Saturday took the supercharged miata to the track for a slalom race. But i did not make it... 5Km before the track a pipe of the power steering broke, and put oil in the whole engine

Gauge holder Part 2

May

I decided to make the holder myself. I could not find a pipe a the hardware store that would fit the gauges. They were either just to small, are to big. So i first put some wax on the meter, than

Gauge holder Part 1

May

Since the car is running, and we are going to start slalom races again, it is time to relocate the pillar gauges. They just blocked my view to much... The mx5 NB / MK2.5 dash does not have much space

Almost done!

May

After the last post, we took here for a little spin. We found out that she was leaking oil and coolant... After a inspection we found that one coolant hose did not have a clamp, and that we forgot to

First start!

Apr

Alright, so we finally got to do the first start yesterday!!! After mounting the supercharger belt, Intercooler and putting all the fluids, it was time. Moment of truth... Would the supercharged

rebuild part 3

Apr

Well we are finally getting there, to have the supercharged miata running again. List of stuff we did: - Mounted pulley, which was a lot more difficult then the original one. - We put back the

Die hard

Apr

Damn, now this is what i call a real die hard! hahaha

catch tank mounted

Apr

Finally had time to mount my D2 Racing oil Catch tank. It was one hell off a job to find a good place for it. Eventually i mounted it in front op the right side wheel. There was a hole i once made

Rebuilt part 2

Apr

So all parts needed to rebuild the supercharged miata engine have arrived! Tomorrow i am leaving on a Holliday to Lapland for 1,5 weeks. So i decided to do some work today before i left. I started

Parts list

Mar

Below a list of parts i ordered to solve my pin problem and get the car running again. I am using a thicker head gasket to lower compression a little. Also the from the bottom of the head, there was

rebuild part 1

Mar

Well somewhere last weak i started wit the rebuild of the engine. First off i had the head resurfaced and fully cleaned. There was only 0.06mm taken off, so should be no change in compression there

Story continues

Mar

Well story continues. Finding a proper solution for the pin problem, was found to be a real quest. Until someone told me to contact Flying miata. They used to have a supercharger setup (ubercharger)